500-220 exam dumps 500-220 exam questions 500-220 freedumps 500-220 practice dumps 500-220 study guide latest 500-220 braindumps

[PDF and VCE] Free Share 500-220 PDF Exam Preparation Materials with Geekcert Real Exam Questions

Geekcert 2021 Valid Cisco 500-220 Cisco Meraki Solutions Specialist Exam VCE and PDF Dumps for Free Download!

500-220 Cisco Meraki Solutions Specialist Exam PDF and VCE Dumps : 57QAs Instant Download: https://www.geekcert.com/500-220.html [100% 500-220 Exam Pass Guaranteed or Money Refund!!]
☆ Free view online pdf on Geekcert free test 500-220 PDF: https://www.geekcert.com/online-pdf/500-220.pdf

100% candidates have passed the Cisco Meraki Solutions Specialist Newest 500-220 vce dumps exam by the help of Geekcert pass guaranteed Cisco Meraki Solutions Specialist Hotest 500-220 free download preparation materials. The Geekcert Cisco PDF and VCEs are the latest and cover every knowledge points of Cisco Meraki Solutions Specialist Newest 500-220 free download Cisco Meraki Solutions Specialist certifications. You can try the Q and As for an undeniable success in Dec 14,2021 Hotest 500-220 practice exam.

Geekcert – our goal is to help all candidates pass their 500-220 exams and get their certifications in their first attempt. money back guarantee. Geekcert 500-220 certification exam dumps. Geekcert – the most professional provider of all 500-220 certifications. pass all the 500-220 exam easily. updated 2016 for all 500-220 top certifications | Geekcert .

We Geekcert has our own expert team. They selected and published the latest 500-220 preparation materials from Cisco Official Exam-Center: https://www.geekcert.com/500-220.html

The following are the 500-220 free dumps. Go through and check the validity and accuracy of our 500-220 dumps.If you need to check sample questions of the 500-220 free dumps, go through the Q and As from 500-220 dumps below.

Question 1:

When an SSID is configured with Sign-On Splash page enabled, which two settings must be configured for unauthenticated clients to have full network access and not be allow listed? (Choose two.)

A. Controller disconnection behavior

B. Captive Portal strength

C. Simultaneous logins

D. Firewall and traffic shaping

E. RADIUS for splash page settings

Correct Answer: AB

Reference: https://documentation.meraki.com/MR/Access_Control


Question 2:

Refer to the exhibit. Assuming this MX has established a full tunnel with its VPN peer, how will the MX route the WebEx traffic?

A. WebEx traffic will prefer WAN 2 as long as it meets the thresholds in the “Conf” performance class.

B. WebEx traffic will prefer WAN 1 as it is the primary uplink.

C. WebEx traffic will prefer WAN 2 as long as it is up.

D. WebEx traffic will be load-balanced between both active WAN links.

Correct Answer: B


Question 3:

For which two reasons can an organization become “Out of License”? (Choose two.)

A. licenses that are in the wrong network

B. more hardware devices than device licenses

C. expired device license

D. licenses that do not match the serial numbers in the organization

E. MR licenses that do not match the MR models in the organization

Correct Answer: BC

Reference: https://documentation.meraki.com/General_Administration/Licensing/Meraki_Licensing_FAQs


Question 4:

Refer to the exhibit. Which two actions are required to optimize load balancing asymmetrically with a 4:1 ratio between links? (Choose two.)

A. Change the primary uplink to “none”.

B. Add an internet traffic preference that defines the load-balancing ratio as 4:1.

C. Enable load balancing.

D. Set the speed of the cellular uplink to zero.

E. Change the assigned speeds of WAN 1 and WAN 2 so that the ratio is 4:1.

Correct Answer: BC


Question 5:

Which Cisco Meraki best practice method preserves complete historical network event logs?

A. Configuring the preserved event number to maximize logging.

B. Configuring the preserved event period to unlimited.

C. Configuring a syslog server for the network.

D. Configuring Dashboard logging to preserve only certain event types.

Correct Answer: A


Question 6:

Which design requirement is met by implementing syslog versus SNMP?

A. when automation capabilities are needed

B. when proactive alerts for critical events must be generated

C. when organization-wide information must be collected

D. when information such as flows and client connectivity must be gathered

Correct Answer: D

Reference: https://documentation.meraki.com/General_Administration/Monitoring_and_Reporting/Meraki_Device_Reporting_-_Syslog,_SNMP,_and_API


Question 7:

Refer to the exhibit. The VPN concentrator is experiencing issues. Which action should be taken to ensure a stable environment?

A. Add a deny any/any firewall rule to the end of the firewall rules.

B. Remove the connection from Internet 1.

C. Physically disconnect all LAN ports.

D. Configure the MX appliance to Routed mode on the Addressing and VLANS page.

Correct Answer: C


Question 8:

Refer to the exhibit. A packet arrives on the VPN concentrator with source IP 10.168.70.3 and destined for IP 10.116.32.4. What is the next hop for the packet, based on this concentrator routing table?

A. The concentrator gateway (10.128.124.62) is the next hop.

B. Not enough detail is available to determine the next hop.

C. The packet is stopped.

D. The Auto VPN peer “Store 1532 ?appliance” is the next hop.

Correct Answer: B


Question 9:

Company iPads are enrolled in Systems Manager without supervision, and profiles are pushed through Systems Manager. Which outcome occurs when a user attempts to remove the “Meraki Management” profile on an iPad?

A. The “Meraki Management” profile cannot be removed.

B. The “Meraki Management” profile is removed and then pushed automatically by Systems Manager.

C. The “Meraki Management” profile is removed. All the profiles that Systems Manager pushed are also removed.

D. The “Meraki Management” profile is removed. All the profiles Systems Manager pushed remain.

Correct Answer: C


Question 10:

Which two features and functions are supported when using an MX appliance in Passthrough mode? (Choose two.)

A. intrusion prevention

B. site-to-site VPN

C. secondary uplinks

D. DHCP

E. high availability

Correct Answer: AB

Reference: https://documentation.meraki.com/MX/Networks_and_Routing/Passthrough_Mode_on_the_MX_Security_Appliance_and_Z-series_Teleworker_Gateway


Question 11:

Refer to the exhibit. What are the Loss and Average Latency statistics based on?

A. responses that the MX appliance receives on the connectivity-testing hostnames on the Insight > Web App Health page

B. responses that the MX appliance receives on the connectivity-testing IP addresses on the Security and SD-WAN > Firewall page

C. responses that the MX appliance receives on the connectivity-testing IP address that is configured on the Security and SD-WAN > SD-WAN and Traffic Shaping page

D. responses that the MX appliance receives on the connectivity-testing IP addresses on the Help > Firewall info page

Correct Answer: B


Question 12:

Which two Systems Manager Live tools are available only for Apple Macs and Windows PCs and cannot be used on iOS or Android mobile devices? (Choose two.)

A. OS updates

B. Send notification

C. Selective wipe

D. Screenshot

E. Remote Desktop

Correct Answer: CE

Reference: https://documentation.meraki.com/SM/Other_Topics/Systems_Manager_FAQ


Question 13:

What are two ways peers interact with ports that Auto VPN uses? (Choose two.)

A. For IPsec tunneling, peers use high UDP ports within the 32768 to 61000 range.

B. Peers contact the VPN registry at UDP port 9350.

C. For IPsec tunneling, peers use high TCP ports within the 32768 to 61000 range.

D. Peers contact the VPN registry at TCP port 9350.

E. For IPsec tunneling, peers use UDP ports 500 and 4500.

Correct Answer: BC

Reference: https://documentation.meraki.com/MX/Site-to-site_VPN/Meraki_Auto_VPN_-_Configuration_and_Troubleshooting


Question 14:

What occurs when a configuration change is made to an MX network that is bound to a configuration template?

A. The configuration change in the bound network is combined with the template configuration inside the template.

B. The more restrictive configuration is preferred.

C. The configuration change in the bound network overrides the template configuration.

D. The template configuration overrides the configuration change in the bound network.

Correct Answer: A

Reference: https://documentation.meraki.com/General_Administration/Templates_and_Config_Sync/Managing_Multiple_Networks_with_Configuration_Templates


Question 15:

One thousand concurrent users stream video to their laptops. A 30/70 split between 2.4 GHz and 5 GHz is used. Based on client count, how many APs (rounded to the nearest whole number) are needed?

A. 26

B. 28

C. 30

D. 32

Correct Answer: C


Geekcert exam braindumps are pass guaranteed. We guarantee your pass for the 500-220 exam successfully with our Cisco materials. Geekcert Cisco Meraki Solutions Specialist exam PDF and VCE are the latest and most accurate. We have the best Cisco in our team to make sure Geekcert Cisco Meraki Solutions Specialist exam questions and answers are the most valid. Geekcert exam Cisco Meraki Solutions Specialist exam dumps will help you to be the Cisco specialist, clear your 500-220 exam and get the final success.

500-220 Cisco exam dumps (100% Pass Guaranteed) from Geekcert: https://www.geekcert.com/500-220.html [100% Exam Pass Guaranteed]